Print Page | Close Window

tercel still cranking after start

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=10331
Printed Date: May 03, 2025 at 5:14 AM


Topic: tercel still cranking after start

Posted By: fanfandede
Subject: tercel still cranking after start
Date Posted: March 02, 2003 at 8:24 PM

i haved installed a remote starter astro mv 802 on a tercel 94,using 12v ; WHITE/ red ,acc ; BLACK / YELLOW ,ing; BLACK/ red ,starter; BLACK/ white , tach;black in check connector

the problem i have  ,when the car start with remote is still cranking and engine running, if im turning the switch to acc ,is stop cranking and still running .somedody  know what's  wrong  ?

thank's for help

-------------
dede



Replies:

Posted By: fanfandede
Date Posted: March 03, 2003 at 6:14 PM

yes i did .

i have two ing wire in harness  do i have to use both  ,may be install a relay ?



-------------
dede



Posted By: jrilla
Date Posted: March 03, 2003 at 7:24 PM
need more information. You say that you hooked up the tach wire, but did you learn the tach signal to the remote starter?

I see you installed a AstroStart MV 802, but I am not familiar with the programming sequence for the tach signal on that particular model. If it is similar to the more recent models of AstroStart you need to program the number of cylinders and the idle speed.

-------------
J Rilla

Owner/Installer



Posted By: fanfandede
Date Posted: March 04, 2003 at 8:15 PM

  i think i have a feed back signal ,tonight a had unpluged the ingnition switcfh and suprize  THE REMOTE WORK PERFECTELY  only if the harness is unplug from the switch, that is possible that ai have to install a relay somewhere bethen the switch and the unit ??

NEED HELP !!!



-------------
dede


Print Page | Close Window