97 Yukon SLT
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=10354
Printed Date: May 31, 2024 at 9:53 PM
Topic: 97 Yukon SLT
Posted By: almo
Subject: 97 Yukon SLT
Date Posted: March 03, 2003 at 1:30 PM
Hello Everyone,
I have been able to find the wiring diagram for my truck through other threads. What I haven’t found are the resistor values for the positive door locks and how they should be wired through the relays. Any help would be greatly appreciated.
Capt. Al
Replies:
Posted By: Haku
Date Posted: March 03, 2003 at 2:38 PM
Four door versions are positve trigger for doors, no resistor needed. Two door models are 5-wire locks, with no resistor needed. Is your a two of four door model, also what is the output from your alarm for the locks.?? Postive or Negative..
------------- Hak
Siemens Autostart
Posted By: almo
Date Posted: March 03, 2003 at 4:03 PM
I have the four door model Yukon and I will most likely be using the UNGO KE106. I used this model before on a stratus with positive door locks and because it was a single wire door I had to use resistors.
I just realized the Yukon has two wires.
The Ungo has 5 wires for the door lock harness thay are:
WHITE/ Black: Lock #87A (Normally Closed)
GREEN/ Black: Lock #30 (Common)
Blue/Black: Unlock #30 (Common)
BROWN / Black: Unlock #87A (Normally Closed)
Violet/Black: Lock/Unlock #87 (Normally Open) [10A fused]
How should I wire them up?
Posted By: almo
Date Posted: March 04, 2003 at 9:39 AM
Thanks For the info. I'll take a look this weekend!
|