Adjust Installed System
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=10369
Printed Date: July 27, 2025 at 8:38 AM
Topic: Adjust Installed System
Posted By: bozo1
Subject: Adjust Installed System
Date Posted: March 03, 2003 at 6:30 PM
How can I adjust an existing alarm system to NOT reset itself when left alone. I need it to set only when the owner pushes the remote button. 2000 Toyota Tundra v8 4wd Access Cab Thanks. ------------- bozo1
Replies:
Posted By: auex
Date Posted: March 03, 2003 at 6:59 PM
Need to know more about the alarm, Make? Model?
-------------
Certified Security Specialist
Always check info with a digital multimeter.
I promise to be good.
Tell Darwin I sent you.
I've been sick lately, sorry I won't be on much.
Posted By: Scott35
Date Posted: March 03, 2003 at 7:32 PM
Ok, If this is a factory RS3000 setup, try this. Insert the key into the ignition switch, turn it to on, not acc. Using a remote control, press and hold both buttons at the same time for over 2 seconds, until the Status monitor LED turns on. You must perform the next step within 30 seconds. Press and release the top remote button twice, there should be 2 chirps, and the exterior lights flash twice. Then turn the ignition switch to the lock position. There should be 3 more chirps and exterior lights should flash 3 times.
|