Print Page | Close Window

setting up relays for door locks

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=103852
Printed Date: May 03, 2025 at 12:55 PM


Topic: setting up relays for door locks

Posted By: 2003kawasaki
Subject: setting up relays for door locks
Date Posted: April 09, 2008 at 8:20 AM

I realy need some help here. I am trying to install a relay setup for an 2005 altima, so that the drivers door opens first then all door after. What I need is a diagram of what wire go where on the relays. I am installing a audiovox XRO9100.

Thanks,

Kurt




Replies:

Posted By: Chris Luongo
Date Posted: April 09, 2008 at 8:57 AM
It's not in the installation manual? All the regular Audiovox stuff I install has it, in the section that describes the various doorlock setups.



Posted By: 2003kawasaki
Date Posted: April 09, 2008 at 9:16 AM

Thanks

I found iit in the manual. I was looking for three relay setup. The manaul wants me to use the factory relays for the pax and rear doors and an additional relay for the drivers door.  I hate it when it is stearing you right in the face.


Print Page | Close Window