Print Page | Close Window

08 expedition bypass

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=103938
Printed Date: July 06, 2025 at 2:20 AM


Topic: 08 expedition bypass

Posted By: qdaddy
Subject: 08 expedition bypass
Date Posted: April 12, 2008 at 11:46 PM

xk-04 bypass not learning keys any suggestions?   thanx




Replies:

Posted By: techman93
Date Posted: April 13, 2008 at 12:37 AM
The firmware should be PKF3 and the orange wire off the module to ignition 12v+ source. Make sure the sequence from the theft light and timing key turning might be off when you turn ignition on from first key. What model remote starter are you installing? Would it be an Audiovox piece?
If it is you will need to jump wire from 12v+ constant to ignition right after theft light goes out from second key being turned. You also have to ground the module brown wire at the same time. I have created a special relay pack for this issue.
Make sure if this doesn't work that the programming hasn't been locked out by the dealer.

-------------
The wire I'm test'n isn't doin' what it's supposed to be doin'... I am so glad I printed that tech sheet, with the wrong info.
Do it right the first time... or I might have to fix it for ya



Posted By: qdaddy
Date Posted: April 13, 2008 at 11:22 AM
viper alarm rs thanx


Print Page | Close Window