Print Page | Close Window

07 chrysler 300 c

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=104135
Printed Date: July 15, 2025 at 1:25 AM


Topic: 07 chrysler 300 c

Posted By: kondziolka
Subject: 07 chrysler 300 c
Date Posted: April 20, 2008 at 4:28 PM

Hey everyone first let me say that this is a great site and I hope I can help out too. I'm going to be installng a alarm remote starter on a 2007 300c on sat. and was wondering if anyone has done this car before? Thanks in advance for any help.

-------------
Where ever there is a problem there is opportunity.



Replies:

Posted By: i am an idiot
Date Posted: April 20, 2008 at 4:52 PM
 Battery LIGHT BLUE/RED (+) IGNITION SWITCH HARNESS 
posted_imageIgnition 1 PINK/WHITE (+) IGNITION SWITCH HARNESS 
posted_imageStarter 1 PINK/DARK GREEN (+) IGNITION SWITCH HARNESS posted_image
posted_imageAll Door Trigger YELLOW/WHITE (+) IN HARNESS IN PASSENGER SIDE WINDSHIELD PILLAR posted_image
posted_imageLF Latch VIOLET (-) IN HARNESS IN DRIVER KICKPANEL 
posted_imageRF Latch VIOLET/WHITE (-) IN HARNESS IN PASSENGER KICKPANEL 
posted_imageLR Latch VIOLET/GRAY (-) IN HARNESS IN DRIVER KICKPANEL 
posted_imageRR Latch VIOLET / YELLOW (-) IN HARNESS IN PASSENGER KICKPANEL 
posted_imageTrunk Trigger VIOLET/ORANGE (-) IN HARNESS IN PASSENGER KICKPANEL 
posted_imageParking Lights WHITE/ VIOLET (+) IN HARNESS IN PASSENGER KICKPANEL posted_image
posted_imageLow Crr Pk Lights WHITE/ BROWN (-) AT VEHICLE HEADLIGHT SWITCH posted_image
 

Starter 1 note   NOT ON ALL MODELS, FOR REMOTE START INFORMATION

All Door trigger note  TO AVOID DOMELIGHT DELAY USE INDIVIDUAL DOOR TRIGGERS AND DOUBLE DIODE ISOLATE EACH WIRE

Parking Light note  USE A 1.6K OHM RESISTOR 

Low Current parking note  (-) THROUGH 1.6K OHM RESISTOR, MUST ISOLATE FROM SWITCH WITH RELAY





Posted By: i am an idiot
Date Posted: April 20, 2008 at 5:02 PM
The above info is for the 3.5L




Posted By: kondziolka
Date Posted: April 20, 2008 at 5:31 PM
Thanks for the info. Am I still going to use doc 1084 for this install?

-------------
Where ever there is a problem there is opportunity.




Posted By: i am an idiot
Date Posted: April 20, 2008 at 6:19 PM
Where did Doc.1084 come from, and how long have you had said document?




Posted By: kondziolka
Date Posted: April 21, 2008 at 12:06 PM
It is the the same directed tech tip that has been around for a few years pertaing to negitive second stater through resistors.

-------------
Where ever there is a problem there is opportunity.





Print Page | Close Window