2007 silverado remote start
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=104196
Printed Date: May 15, 2025 at 6:02 AM
Topic: 2007 silverado remote start
Posted By: downlowez
Subject: 2007 silverado remote start
Date Posted: April 22, 2008 at 7:22 PM
hey. i am going to install a viper 791 in my 07 silverado and was looking for the wiring and other info. could someone help a brother out?? thanks in advance !!!!
-------------
Downlowez,,
Replies:
Posted By: Velocity Motors
Date Posted: April 22, 2008 at 8:15 PM
Did you use the search function ? This vehicle has been on the forum tons since it came out.
-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA
Posted By: eclipse_420
Date Posted: April 22, 2008 at 9:42 PM
| 12 Volts | RED / white (2A) | + | ignition harness |
| Second 12 Volts | RED / black (60A), RED / black (60A) | + | fuse box, black 40 pin plug, pins F1 and E3 |
| Starter | yellow/black (not for remote start) | + | ECM, black 73 pin plug, pin 52 | | The ECM (Engine Control Module) is on the driver side fender, behind the headlight. |
| Second Starter | pink/black | +9.6K ohms | ignition harness or BCM, lt. green plug, pin 2 |
| Ignition | pink | + | ignition harness or BCM, lt. green plug, pin 14 |
| Accessory | brown or yellow | + | ignition harness or BCM, lt. green plug, pin 21 |
| Second Accessory | same as second starter wire | +6.3K ohms |
| Keysense | same as second starter wire |
| Data Bus | pink/black (resistor code), white (5V reference) | mux | ignition harness or BCM, lt. green plug, pins 2, 4 | | The BCM (Body Control Module) is to the left of the steering column. |
|
| Power Lock | use interface module |  | | | If interface module is not available. To lock/unlock the driver door go to the driver door module or motor in the door and 5 wire the tan (lock) and purple (unlock) motor wires. To lock/unlock the passenger door go to the passenger door module or motor in the door and 5 wire the tan (lock) and gray/black (unlock) motor wires. To lock/unlock the rear doors use lt. blue (+) and white (-) at the BCM, gray plug, pins 7 and 9. The BCM (Body Control Module) is to the left of the steering column. On the base model trucks, lock is pink/black (-) and unlock is ORANGE / black (-) at the BCM, gray plug. |
|
|
| The BCM (Body Control Module) is to the left of the steering column. |
|
| Meter this wire while turning the key in the driver door key cylinder. The DDM (Driver Door Module) is in the driver door. |
|
|