04 corolla aftermarket power windows
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=104304
Printed Date: May 09, 2024 at 3:53 PM
Topic: 04 corolla aftermarket power windows
Posted By: desh187
Subject: 04 corolla aftermarket power windows
Date Posted: April 27, 2008 at 12:33 PM
Installed a spal power window kit in a 2004 Toyota Corolla(2 front windows only).I used a relay as stated in the spal instruction manual.Everything worked fine for a few hours and then the ignition fuse popped(i had picked ignition from swich harness)
Picked ignition source from fuse block and things were good for about 3 weeks and the windows stopped working.When i tested the igntion source,there was no power there.
Temporarily,i have constant power running instead of switched power and things are working okay.
What should i do?Any feed back will be very much appreciated.
Thanks
Replies:
Posted By: howie ll
Date Posted: April 27, 2008 at 12:40 PM
Battery, fused 30 amp to 87 and 87a, ground to 85, switched ignition to 86, and feed windows from 30
Posted By: howie ll
Date Posted: April 27, 2008 at 4:58 PM
Sorry DON'T connect ANYTHING to 87a
Posted By: Mike M2
Date Posted: April 28, 2008 at 6:40 AM
Yes, the ignition wire you are using should power the relay ONLY, not the windows. It sounds like you have it wired incorrrectly and the windows are getting power from the ignition source...
-------------
Mike M2
Tech Manager
CS Dealer Services
|