aftermarket door lock kit issue
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=104319
Printed Date: November 04, 2025 at 4:23 AM
Topic: aftermarket door lock kit issue
Posted By: tookie
Subject: aftermarket door lock kit issue
Date Posted: April 27, 2008 at 11:59 PM
Hello All,
I bought a combo kit for my daughters car a 1996 Geo Prizm. I got the alarm to work fine, but when i connect to the 2 wire harness made for the add on door lock/unlock it moves the actuators up/down is all.
The alarm is a: Astra 4000RS
The door lock kit is a: Giordan Central door locking system V686.
it doesn't specify any additional relays needed. but it isnt working properly, anyone familar with this model?
Replies:
Posted By: howie ll
Date Posted: April 28, 2008 at 3:42 AM
I have no knowledge of either system but; if your alarm has 2 lock output wires these are most likely to be low current neg. check your install manual. then if your lock kit has a central relay/control unit, you should have 5 wires going from it to the driver's door. 2 will be motor wires probably green and blue, of the other three, 1 wil be black. Ignore the black, the other two wires, ground each in turn, this should lock/unlock the dors, connect alarm wires to these two.
|