command start cs 395 i

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=104614
Printed Date: July 12, 2025 at 10:43 AM

Topic: command start cs 395 i

Posted By: denrich
Subject: command start cs 395 i
Date Posted: May 10, 2008 at 6:52 AM

I have a Command Start remote and the local Nissan dealer erased the transponder signal while programming a new key. Does anyone know how to reprogram it. It has a datalink modual under the dash.

-------------
Richie

Replies:

Posted By: tedmond
Date Posted: May 10, 2008 at 12:28 PM

unplug harnesses to the datalink, hold the programming butotn, plug it back in and the light will light up green for programming mode. place keys into ignition and turn it on, the light will flash 3 times and you relearned it.

Posted By: denrich
Date Posted: May 10, 2008 at 2:26 PM

Thanks , I tried it but didn't work so played around with it like your instuctions and found out that the light had to be red flashing at first when connecting harness and then constant red for learning and didn't become green but flashed green once when learned. I have the Datalink ADS-AL (128) . Now working

-------------
Richie

Print Page | Close Window