Print Page | Close Window

door trigger wire, 1999 acura integra

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=104719
Printed Date: May 05, 2024 at 3:00 AM


Topic: door trigger wire, 1999 acura integra

Posted By: adhuot01
Subject: door trigger wire, 1999 acura integra
Date Posted: May 14, 2008 at 2:27 AM

For a 1999 Acura Integra, I am looking for the segment of (-) trigger wire just before the dome light.  In my wiring diagram, it is labled light GREEN/ red, and its locatioin is described as above the left kick panel.  I have found this wire in several spots in the kick panel area.  The first one probed is grounded when the door is open, but when I cut the wire the dome light stayed on.  Two others were not grounded with the door switch.  I found one junction harnes way in the back that had three of these wires in it, one grounded with the door switch, one gave some sort of pulse on my multimeter and the other was not grounded and I am not sure if it went only to the dome light.  

I have built a timer circuit to control my dome light (and only the dome light), but it requires a (-) trigger input, which I have already located, and an output wire (-) that goes directly to the dome light ground.  I removed the dome housing and found that the ground wire is in fact the same color scheme (light GREEN/ red), but the wire was obviously a higer gauge than any of those I could find around the kick panel.

Where can I locate the appropriate wire that goes directly to the dome light?  I don't want my circuit to output to to other things like the door open indicator in the instrument cluster etc.  Your input will be greatly appreciated.

Thank You

Andy Huot



-------------
Andy Huot



Replies:

Posted By: hydroz_23
Date Posted: May 14, 2008 at 11:28 PM
light GREEN/ red dkp behind cruise control bracket. take out one 10mm bolt pull bracket up a little and its there. there are a couple, its the
thicker one



Posted By: bbullers
Date Posted: May 15, 2008 at 12:54 PM
this wire is in the LARGER of the 2 GRAY Plugs in the LOWER DRIVERS KICK near the FIREWALL. If vehicle is equipped with a Cruise Control, these plugs are behind this module. You must remove this module to access these plugs. this BLUE tach wire is also located in a 16-Pin WHITE or GRAY Plug to the LEFT of the FUSEBOX.


-------------
The Only Stupid Question, is the one Un-asked


Print Page | Close Window