2008 civic si siren location

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=104995
Printed Date: April 28, 2024 at 10:21 AM

Topic: 2008 civic si siren location

Posted By: ruki101
Subject: 2008 civic si siren location
Date Posted: May 25, 2008 at 5:51 PM

Hello! I'm thinking of installing an alarm/RS on my 08 Civic, as I checked the locations on where to mount the siren I noticed right away how crowded the engine bay so, I'd like other installers input on where to mount it. Also, is there a pre-drilled hole where can I ran the wires going to engine bay?

Thanks in advance!!!

-------------
Just About Anything Sparks

Replies:

Posted By: SOUND PRESSURE
Date Posted: May 25, 2008 at 8:56 PM

Hey ruki,

I usually put a siren under the trunk area as a backup. This might be another area for you to look around to hide one up in there. It will get wet so make sure that it is aiming downward. Also be prepared because it is louder. Hope this helps some what.

-------------
Sound Pressure

You know you have the right amount of pressure when your eyes start to water! Now you've got Juice!

Posted By: howie ll
Date Posted: May 26, 2008 at 11:02 AM

The pre drilled hole is called a grommet and cable should pass through it already, look at bulkhead at back of engine bay around driver's side.

Posted By: ruki101
Date Posted: May 26, 2008 at 1:48 PM

Thanks Sound Pressure & Howie.

PS: Howie, groomet is the rubber or plastic that goes around the hole to ensure not to damage the cable passing through the hole. Just a correction not a flame.

Thanks again!

-------------
Just About Anything Sparks

Print Page | Close Window