04 honda odyssey sec interface

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=105149
Printed Date: May 09, 2025 at 1:20 PM

Topic: 04 honda odyssey sec interface

Posted By: albertatech
Subject: 04 honda odyssey sec interface
Date Posted: May 31, 2008 at 12:03 PM

I am installing a Viper 5900 and the XK02 instructions indicate a "Data wire (thin Brown wire) on a female connector located from driver door, wire side of fuse box, pin A15." I cant find this wire. Is there another data wire that will for sure work? Pin 2 on the ALDL OBDII connector isnt there, no pin 2 and its too old for CAN bus. Some modules connect to the cylinder but this one calls for behind the fuse box.

Replies:

Posted By: jmsounds
Date Posted: May 31, 2008 at 12:57 PM

i use fortin and the instruction says you can find the wire at the transporder key connector data i done a few hondas and will always be there the data wire is BLUE/GREEN PIN #2 good luck

Posted By: JWorm
Date Posted: May 31, 2008 at 1:16 PM

Wiggle the harness in the drivers door jam. Can you see where that harness goes into the car? Its in that harness.

Posted By: albertatech
Date Posted: May 31, 2008 at 4:04 PM

I HATE door harnesses... lol. Thanks for the tips, should get it now.

Print Page | Close Window