Print Page | Close Window

550hf clear / reset transmitters?

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=105208
Printed Date: May 16, 2025 at 12:01 PM


Topic: 550hf clear / reset transmitters?

Posted By: ziesemer
Subject: 550hf clear / reset transmitters?
Date Posted: June 02, 2008 at 7:38 PM

Thanks to some other links on this site, I finally found both the owner's guide and the installation guide for the 550HF.

(The installation guide I'm referencing is named "N550HF.pdf" but is titled "553 Series Installation Guide".)

Neither seem to indicate how to clear / reset all programmed transmitters / remotes. Any ideas?

I had one slightly working remote (buttons going bad). I just bought 2 replacements. I was able to program one but not the other. I'm thinking only 2 remotes are programmable per system on this model? Assuming so, I'm thinking that I need to clear/reset the existing remotes to get the 2 new ones to work.

Thanks!



Replies:

Posted By: Big Dog
Date Posted: June 03, 2008 at 9:24 AM

Does your module have a small sliding door under which there are 4 dip switches and two jumpers? If so use this.

One jumper is light flash polarity the other is TX learn. Don't forget to place the jumper into the learn position. You'll see a small "L" printed on the PCB.

It accepts up to 4 transmitters. Adding a fifth bumps out the first, etc.



-------------
Prepare your future. It wasn't the lack of stones that killed the stone age.


Print Page | Close Window