programming crimestopper remotes
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=105254
Printed Date: May 14, 2025 at 1:49 PM
Topic: programming crimestopper remotes
Posted By: TooDark
Subject: programming crimestopper remotes
Date Posted: June 04, 2008 at 10:20 PM
I can not figure how to program the remote for a second car. I know to operate the remote for the second car you have to press * to light red light to operate second, but how in the heck to program the remote to the unit?
Replies:
Posted By: todds440
Date Posted: June 05, 2008 at 7:18 AM
You have to program both sets of remotes to each vehicle. Then you use the side button to select vehicle 2. 1. Open hood (ground the Gray hood pin wire if no hood pin is installed.) 2. Turn key to the ON position. (Do not start vehicle) Pink wire must be connected!3. Press Program/Valet button 4 times. Wait for the unit to flash the parking lights and/or honk horn exactly 4 times. 4. RS1300 series: Press Button #1 (Lock) of the transmitter to be learned. RS1604TW1/1704TW2/1804FM: Both the Lock & Unlock buttons must be pressed. You should get 2 light flashes and 2 horn honks indicating the code-learn.Now the unit is waiting for a 2nd code, so repeat this step as needed with up to 3 additional remotes. The unit will flash the lights in succession after each code learned for up to 4 codes. (3 flashes for the 2nd code, 4 flashes for the 3rd code and 0 for 4th code.) If all 4 codes are learned, the unit will automatically exit code learning mode, otherwise turn key OFF and close the hood. IGN OFF
Posted By: bbullers
Date Posted: June 05, 2008 at 11:16 AM
Posted By: TooDark
Date Posted: June 05, 2008 at 1:47 PM
Got it but, I want to know how to program the second car option with the remotes?
Posted By: bbullers
Date Posted: June 06, 2008 at 12:21 AM
Try repeting the process on both units
-------------
The Only Stupid Question, is the one Un-asked
|