2007 chrysler 300, base model

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=105440
Printed Date: May 03, 2024 at 7:55 AM

Topic: 2007 chrysler 300, base model

Posted By: mendozalester
Subject: 2007 chrysler 300, base model
Date Posted: June 12, 2008 at 2:06 PM

Does someone have the alarm diagrams for this car, I see that there is for 08, 06, 05 but not 07 and need to know if they are the same, Thanks.

Replies:

Posted By: another-kelly
Date Posted: June 12, 2008 at 4:23 PM

should be the same.

https://64.85.6.121/diagrams/printpage.asp?ModelID=17150&MakeID=14

Posted By: mendozalester
Date Posted: June 12, 2008 at 5:02 PM

cool, Thanks.

Now a question about dome light wiring. This car has separate triggers for each door, is it possible to just wire my dome light wire from alarm to the cars dome light wire, for an easier install.

Posted By: dtk1
Date Posted: June 12, 2008 at 6:08 PM

it could be done how ever there would be a delay

Posted By: mendozalester
Date Posted: June 20, 2008 at 1:58 PM

follow up......

I hooked up my dome light & trigger wire the the back of the instrument cluster pin #12 and it all worked very well!!! There is no delay for domelight supervision and the trigger works as it should (altough I have to say that there is about a 1sec or 2 second delay when a door is opened and the alarm is triggered. that is ok with me becasue all the work that it saved me, especially for a do it yourselfer. Thanks to all experienced installers and your advice!

One thing that I'm still working in is the trunk release to work. I have looked up different diagrams in wiring my relay but there must be something I'm doing wrong. the diagram tells the that the wire is PURPLE / tan (-) requires relay, location at the trunk switch. I found the wire and noticed that the wire rests at a positive voltage until the swith is pressed and then shows no voltage. First, I tried to hook up my gray wire from the alarm module (acc #1 trunk release, neg out, 250Ma) it worked once or twice and then it stopped working. Then I tried to use with relay using this diagram, this didn't work either. What am I doing wrong???????? posted_image

Posted By: StealthEs
Date Posted: June 28, 2008 at 5:26 PM

Sound like you fried the output of the trunk release from you unit. Test it with a meter to see if its still working.

-------------
Cris