dodge journey remote start
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=105571
Printed Date: April 30, 2024 at 9:55 AM
Topic: dodge journey remote start
Posted By: andyboro
Subject: dodge journey remote start
Date Posted: June 19, 2008 at 10:56 AM
There is a new ignition, no violet-brown wire as a second starter. No starter wire. Any idea with remote starter installation? ------------- Andy
Replies:
Posted By: andyboro
Date Posted: June 19, 2008 at 11:31 AM
ok, I found that is like Caravan 2008, and XK06 with firmware SICH1 gonna works with.
-------------
Andy
Posted By: enice
Date Posted: June 19, 2008 at 4:49 PM
Use the module that Fortin Makes....You must use a Compustar or comparable model to make it work but it will not void the vehicles warranty as a XK06 needs to be hard wired into the module next to the key cilinder. You damage that module and you will be guaranteed a visit to the Dealer for a pretty penny. Go to ifar.ca and search that vehicle.
Posted By: hydroz_23
Date Posted: June 19, 2008 at 11:41 PM
this car is very easy to do if you solder to the other board. hard to mess up if go to the inside board. it takes me 15 min to remove,
solder and replace. i am impressed with the fortin piece, but its not really a time saver cuz your still doing the same amount of work and you
still have to use another module for everything else or hardwire. it wont be long before someone just makes that add on circuit board and then you could connect any module without soldering. anyways i have used
everything available for these cars and the idatalink piece is by far the best. one module that does everything igniton, locks, transponder and also gives you brake, parking light and tach outputs.
Posted By: dtk1
Date Posted: June 19, 2008 at 11:47 PM
I recommend you xk06 bypasskit.com
Posted By: hydroz_23
Date Posted: June 19, 2008 at 11:54 PM
dtk1] wrote:
I recommend you xk06 bypasskit.com
xko6
plus a pku-ch2
plus a xk07 (if you have the right data port)
hmmm!
Posted By: extreme1
Date Posted: June 20, 2008 at 12:43 AM
Idatalink ADS-AL-CA + ADS-RNGC2
easiest install, EASIEST transponder programming.
-------------
Shaughn Murley
Install Manager, Dealer Services
Visions Electronics
Red Deer, Alberta
Posted By: hydroz_23
Date Posted: June 20, 2008 at 8:16 AM
i agree. you can also use ads-dlsl-ch3 which comes with the ring
|