viper 5701 wires

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=105766
Printed Date: May 02, 2025 at 4:58 PM

Topic: viper 5701 wires

Posted By: japreston
Subject: viper 5701 wires
Date Posted: June 28, 2008 at 5:52 PM

Installing the 5701 in my 2000 GMC Savana work van and was wondering what the following connections are for. Pink/white is for ign. 2/flex relay output. RED / white (30a) fused ignition 2/ flex relay input 87. pink/black flex relay input87a key side. RED / black fused (30a) accessory/ starter input.

-------------
Car Audio is like a woman, can bring so much enjoyment and frustration at the same time! But who could live without either.

Replies:

Posted By: chriswallace187
Date Posted: June 30, 2008 at 9:53 PM

The RED / white and RED / black are constant power inputs - DEI handily gives you information on what relay(s) draw from each so you could connect them to the appropriate constant power wire on a vehicle where it mattered(on your van it doesn't matter).

If you haven't connected the flex relay, on your van it should go to the white 2nd ignition wire in the harness. The 87a input can be ignored. Make sure the flex relay is programmed as an ignition.

-------------
C Renner's Auto Electronix
My service is cheap, quick, and good - pick any two

Posted By: lstarno
Date Posted: July 15, 2008 at 11:58 AM

Thanks that helped me out. Follow up question...

For the RED / white and red wires do you just cut igntion one/two and wire into them, then connect the other side of ignition one/two and connect to Pink and Pink/White?

Thanks