Print Page | Close Window

rv alarm door lock problem

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=105975
Printed Date: May 13, 2024 at 9:49 AM


Topic: rv alarm door lock problem

Posted By: audioinstaller3
Subject: rv alarm door lock problem
Date Posted: July 07, 2008 at 7:37 PM

I'm putting an alarm in a customers RV its a 01 Ford E450 made by Jayco. I can only get the driver door to lock and unlock using a 5 wire relay hook up. I can't get the passenger side to work. The wire colors on the car that I used were driver door lock pink/black. Driver unlock pink/orange. Passenger door lock red, pass. unlock brown. The wires test at like 1.5 millivolts. Then when I hit the switch go to 0v then directly to 12v. I tried just hooking up the door lock wires by themselves but it did nothing. I need help. The alarm is a basic autopage rf-315. Thanks



Replies:

Posted By: audioinstaller3
Date Posted: July 07, 2008 at 9:47 PM
Could someone explain the right way to wire up a five wire door lock?




Posted By: audioinstaller3
Date Posted: July 07, 2008 at 10:09 PM
Ok I just found out its a 5 wire reverse polarity door lock. So how do I wire this up. Do I still use the relays?




Posted By: tedmond
Date Posted: July 08, 2008 at 8:39 AM

you will use 2 relays. and follow this diagram.

https://www.the12volt.com/doorlocks/page3.asp#5w





Posted By: jim hunter
Date Posted: July 08, 2008 at 9:42 AM
probably like the e150-e350 vans, red(unlock) and brown(lock) are lock unlock reverse polarity with passenger switch being master if vehicle didnt have factory keyless, if it has factorykeyless wires will be negative pink/lt green(u/l) and pink / YELLOW(l)if no keyless 5 wire relays ---pin85 to negative lock output from system, pin 86&pin87to 12 volt constant,pin 87a to switch side(side that still lights testlight when hitting lock on pass switch) pin 30 to motor(side going into driver door boot)of brown wire
use same relay wiring for red unlock except pin85 use negative unlock output from your system




Posted By: audioinstaller3
Date Posted: July 08, 2008 at 6:34 PM
Ok thanks I got it finished today. It was the way Jim Hunter said. So thanks for the great info.





Print Page | Close Window