cavalier passlock 1 question
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=10608
Printed Date: May 21, 2024 at 10:28 AM
Topic: cavalier passlock 1 question
Posted By: Duston
Subject: cavalier passlock 1 question
Date Posted: March 08, 2003 at 6:24 PM
Any help here would be great. Car starts for about 5 sec and then dies security light blinks. I have the right bypass for it but i think the problem is the bulb test wire not sure if i have the right one from the black 6-pin connector? Any other trouble shooting ideas i can try?
-------------
Factory security systems suck!
Replies:
Posted By: jrilla
Date Posted: March 09, 2003 at 8:42 AM
The bulb test wire is the thin blacl wire in th same harness as the two Red power wires if I remember correctly. I have never had a bypass kit work on a cavalier though so i use relays and a resistor.
What year cavalier and what bypass modules are you working with?
Here is a permanent bypass method that uses relay and resistor. If you want a tewmporary bypass method just email me and I will send one to you.
Passlock I Bypass (Diagram #1)
You may need to copy and paste this into a new window if the link does not work:
https://12voltinstallations.8m.com/photo.html ------------- J Rilla
Owner/Installer
Posted By: Velocity Motors
Date Posted: March 09, 2003 at 4:21 PM
What year Cavalier do you have ? Just want to verify the Passlock system you have in the car .
-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA
Posted By: Duston
Date Posted: March 09, 2003 at 6:37 PM
95 cavalier passlock 1 i bought a dei 555L bypass hooked it all up and the light stays solid when it starts and it seems to work but then it dies.
-------------
Factory security systems suck!
Posted By: jrilla
Date Posted: March 09, 2003 at 6:42 PM
Yeah your bypass module is the problem, unless of course you do not have it hooked up right.
Like I said I have never had a bypass module that worked on a cavalier with Passlock I. Maybe just bad luck, maybe just the bypass modle I was using, but I only use relays and a trimpot now, for cavaliers.
-------------
J Rilla
Owner/Installer
Posted By: Duston
Date Posted: March 09, 2003 at 6:54 PM
hey J Rilla i'll try your method on bypassing with a relay, question on the Vehicle start wire side ( just run the wire from pin 85 to the vehicle start wire yellow right? and then RS start output connect to the same wire.. thanks for the help also i need to get the same resistor from testing the yellow passlock wire and the black passlock wire correct.. hope this works because i have put to many hours in this security system..  ------------- Factory security systems suck!
Posted By: jrilla
Date Posted: March 09, 2003 at 7:02 PM
Oh dont worry, as long as you have the right bulb test wire, and the right resistor it will work.
Yes, you just need to run a wire from the starter to pin 85. If you installed a starter kill, or anti-grind relay, you need to put pin 85 on the starter side of the relay where the RS starter output is.
-------------
J Rilla
Owner/Installer
Posted By: MBS AUDIO
Date Posted: March 10, 2003 at 6:14 PM
Just another note about the bulb test wire on these cars. They are in the harness with the power wires in location "D" or "E". The letters are on the side of the harness. Also, the wire is small, but not always black. Sometimes it is green or brown.
Posted By: Duston
Date Posted: March 10, 2003 at 7:40 PM
thanks everybody for your inputs, got the cavalier to start and stay running. One relay i had was bad so i tried another and it worked fine, next i need to bypass a 2001 cavalier passlock 2 and a pontiac sunfire passlock 2 also any more diagrams to bypass those two.. (J Rilla) thanks alot  ------------- Factory security systems suck!
Posted By: Velocity Motors
Date Posted: March 10, 2003 at 8:46 PM
https://www.the12volt.com/downloads/file.asp?ID=250 ------------- Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA
Posted By: jrilla
Date Posted: March 10, 2003 at 10:21 PM
I use this one: Look at diagram #2
Passlock II Temorary Bypass------------- J Rilla
Owner/Installer
|