viper 550hf transmitter
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=106475
Printed Date: July 13, 2025 at 11:01 PM
Topic: viper 550hf transmitter
Posted By: saskpuller
Subject: viper 550hf transmitter
Date Posted: July 30, 2008 at 8:52 PM
Have a older Yukon in getting the r/s working again. Got everything going but can't seem to get the LED light on the transmitter to respond to anything. It stays on solid. It's a 2 button remote. Door locks with button I and nothing on button II that I can tell. Both buttons to start. What can I do to get this LED to shut off and work properly?
Replies:
Posted By: Mark Mizenko
Date Posted: July 31, 2008 at 3:40 PM
Sounds like it's in valet mode, turn the ignition ON, then OFF, then press and release the valet pushbutton, and the LED should go out. If the systemids new enough, you can..... with the drivers door OPEN, press button ONE, then button TWO then button ONE again, and the LED should go out. Let us know if you still have a problem. Mark.
Posted By: kgerry
Date Posted: August 01, 2008 at 11:42 AM
i have never seen the light on the remote stay on in valet mode, only the LED on the dash... sounds like it might be a bum remote....
-------------
Kevin Gerry
Certified Electronics Technician
MECP First Class Installer
Owner/Installer
Classic Car Audio
since 1979
|