clifford 3.3x remote start on wk srt8
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=106526
Printed Date: May 11, 2025 at 6:52 PM
Topic: clifford 3.3x remote start on wk srt8
Posted By: a137
Subject: clifford 3.3x remote start on wk srt8
Date Posted: August 02, 2008 at 8:52 AM
Started installation this morning.
1. Programmed XK532 bypass (both stages - transponder and the module itself)
At XK module:
Connected Red and Black to constant +12 and ground
violet/white to violet/brown at ignition harness ( is it correct??)
Pink - to pink/orange at ignition harness
violet to pin 6 at SKIM module
brown to Blue RS status at Remote start output harness at Clifford
2. Wired Clifford 3.3X using D2D cable to XK532 (dip switches horisontal)
Wired RED, RED / White, RED / black at H3 harness and Red on H1 harness to constant 12 volt (battery).
Green starter - to key side of cut starter wire (pink/orange at ignition harness)
violet starter - to car side of cut starter wire (pink/orange at ignition harness)
Pink Ignition 1 to Pink/light green wire at ignition harness)
Orange (acessory) - don't know where to ????
Pink/White and Pink/Black - N/C
Black at H1 harness - to ground (the same as for XK, and siren)
Grounded neutral safety switch
Brown (brake) to brake pedal harness (+12 when brake pressed)
Wired siren red wire to brown (siren at H1 harness)
Connected Neutral safety switch (On position)
Leaved tach and Hood pin switch wires N/C
3. reprogrammed 3.3X to auto trans
Alarm and wireless door lock work, Remote start - do not
Can not run tach learn (led does not goes on constantly)
Cannot figure where to hook orange (acessory) wire at H3
What else I'm missing?
Replies:
Posted By: a137
Date Posted: August 02, 2008 at 9:15 AM
The car is jeep WK 06 srt8
|