Print Page | Close Window

viper 5701 and 03 evolution

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=106561
Printed Date: May 16, 2024 at 10:11 AM


Topic: viper 5701 and 03 evolution

Posted By: johnjonfenomeno
Subject: viper 5701 and 03 evolution
Date Posted: August 04, 2008 at 6:29 AM

Ok so I have everything installed in the car and the alarm works fine. 

With the exception of the domelight supervision. 

But more importantly.  I need help with the ignition wires.

Here are my wires from the car.

Function           polarity                    Vehicle Wire

Constant             +                              white

Ignition                +                              blk/wht

Accessory           +                              blu/wht

Accessory 2        +                              blu/blk

Starter                  +                               blk/yel

so, so far this is my alarm connection

alarm                         vehicle

pink                             blk/wht

RED / wht                        not connected

orange                         blu/wht

violet                             blk/yel (S)

green                            blk/yel (k)

red                                 wht

pnk/wht                         blu/blk

pink/blk                         not connected

RED / blk                           not connected

....................................................................................

Im getting confused about the accessory 2 wire .. Im reading that according to my connection this has to be programmed as an accessory circuit?  If this is the case what other wires do I have to connect.  

So far with this connection.. you can initialize rs by hitting the brake pulling ebrake releasing brake and hittings rs open door and upon arming the car shuts off.  But when you try to restart the car wont go.  I dont need a bypass since i removed the immobilizer I am using a different ecu a stand alone engine management system.

Any help is appreciated




Replies:

Posted By: howie ll
Date Posted: August 04, 2008 at 12:10 PM
Did a remote start on a Pajero (Jap import Shogun /Montero) and colours were as follows:- Ign1  Blue/Black Ign2 Blue/Red, starter BLACK / YELLOW, Acc Blue / YELLOW, 12v at switch, Blue/White, checvk your ignitions, 1 is the circuit that stays live on cranking, 2 will dump.



Posted By: johnjonfenomeno
Date Posted: August 04, 2008 at 12:42 PM
I only have one ignition .. Its not a two ignition model



Posted By: johnjonfenomeno
Date Posted: August 05, 2008 at 9:46 AM
I think I figured it out the starter wire is seeing voltage upon the RS activation.. This is the vehicle wont start due to the clutch switch.  The clutch switch needs to be bypassed


Print Page | Close Window