omega ultimate edp wiring diagram
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=106607
Printed Date: May 04, 2024 at 2:55 PM
Topic: omega ultimate edp wiring diagram
Posted By: seve9ineimpala
Subject: omega ultimate edp wiring diagram
Date Posted: August 06, 2008 at 4:03 PM
hey guys, i just recently purchased a 2006 gmc canyon. It did not have power locks from the factory so i decided to wire in some accuators. Anyways i got everything done and than i pulled down the alarm to finish up the wiring. The alarm is an omega ultimate-edp (which was installed before i bought the truck), but does not have any labeling on it to where i would tap in for the door locks. i have searched the net and i can't seem to find a wiring diagram for it anywhere. If anyone can hook me up with a diagram or some insight it would be greatly appreciated. thanks G,
Replies:
Posted By: chillin420
Date Posted: August 06, 2008 at 5:11 PM
it is probably going to be in a 3 pin molex connector. going to be blue and green wires most likely
-------------
you can do it....
advanced MECP, lol does it really matter....
patience is a virtue
Posted By: twistedp
Date Posted: August 06, 2008 at 6:05 PM
 this pic is from a al-2000-edp but yours should look very similar if not the same.
The locks connection should have a 4 pin connector as above.  The pins should be connected as shown. (N/C means no connection.)
pink = (-) 1st door unlock (for 2 stage unlock), blue = (-) unlock or (+) lock, green = (-)lock or (+)unlock. ------------- Twisted Performance
Posted By: seve9ineimpala
Date Posted: August 06, 2008 at 10:02 PM
thanks alot guys this is just what i was looking for
Posted By: seve9ineimpala
Date Posted: October 18, 2008 at 9:04 PM
ok guys so i finally got a chance to take some picture, i went and tried to wire up driver side accuator with a pair of relays using the diagrams i found on the site, but i can not get them to work. If any one can shed some light on which inputs in the picture i uploaded are the right ones for wiring the accuators, it would be greatly appreciated. 
Posted By: twistedp
Date Posted: October 20, 2008 at 12:01 PM
the wires pictured are not for the door locks. the door lock wires are a thinner gauge. the previous installer probably did not connect the plug containing the wires for the door locks. it should be one of the empty plugs on the side of the unit. looking at the picture, on the left side where there is a small four wire plug for the shock sensor. to make a long story short, you will first need the plug for the door locks. once you get one, you will be able to wire the relays according to the actuator diagram on this site.
-------------
Twisted Performance
Posted By: seve9ineimpala
Date Posted: October 21, 2008 at 2:20 PM
thanks man, i was just thrown off because that wide connector says doors on it with the negative and positive trigger markings on it. im gonna assume that its meant for vehicles with factory keyless entry. anyways thanks for the help man i appreciate it.
|