07 aveo, viper 160xv
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=106964
Printed Date: May 12, 2024 at 2:11 PM
Topic: 07 aveo, viper 160xv
Posted By: bullpar
Subject: 07 aveo, viper 160xv
Date Posted: August 22, 2008 at 7:20 PM
I have an 07 Aveo Hatchback and have installed a 160XV. My car has the transponder system installed. I got a diag code of (+/-) shutdown. What does this mean? Also I connected wires for the lock/unlock into the relay under the passenger kickpanel. But it does nothing. And finally when I got to crank it remotly it does nothing. any ideas. Thank you all so much
Replies:
Posted By: bullpar
Date Posted: August 23, 2008 at 7:23 AM
Nobody knows anything about the aveo...
Posted By: kgerry
Date Posted: August 23, 2008 at 9:45 AM
i'm sure lots do... and with a bit more info on your part might be able to help.... what bypass module did you use? did it program successfully? what wires did you tap into for keyless? etc. etc..... ------------- Kevin Gerry
Certified Electronics Technician
MECP First Class Installer
Owner/Installer
Classic Car Audio
since 1979
Posted By: bullpar
Date Posted: August 23, 2008 at 10:58 AM
Thank you for replying, I got everything to work except for the lock/unlock. I'm not sure where to hook into. I connected to the central door lock box on the RH side of the car but that doesnt work. I can hear relays under the center console. on that box (under the e-brake handle) it says its the alarm but there is a small antenna coming out of it. I have a feeling thats where i need to hook into. But which wires. Whats strange is My car has the transponder key system but the 160xv will crank the car without a key anywhere near it. Thanks for your help
Posted By: bullpar
Date Posted: September 29, 2008 at 9:26 AM
Hello, I wired a Viper 160xv into my 07 aveo hatchback. I have connected everything except the door locks. I went to the door module on the rh kickpanle like the diagram states but it doesnt work. I do have the transponder system in mine. Where exactly do I connect for the dorrs lock/unlock and the alarm disarm. Whats wierd is I can unlock my car with the original keys and then use the remote start to start it. but if the car is locked the alarm will go off and wont start. I would love to use the viper door lock/unlock because of the range.
Posted By: howie ll
Date Posted: September 29, 2008 at 12:38 PM
Hello again, what's an Aveo (I'm serious it's not sold here), if you know look it up on vehicle wiring on this site. Should give you your answer.
Posted By: howie ll
Date Posted: September 29, 2008 at 1:12 PM
Wrong, it's sold here US models, Aveo Lock Lt. Blue, Unlock White; disarm factory alarm BROWN / blue or purple, all in RKE (Keyless entry module) in centre console adjacent to parking brake. Aveo5 Lock grey, unlock lt. green; at factory lock module, passenger kickwell; disarm factory alarm,dark blue in driver's door loom. All neg going, i.e. ground each to get the result.
Posted By: bullpar
Date Posted: September 29, 2008 at 1:48 PM
Awsome thank you very much. I was looking around and had seen the module just forward of the emerg. brake handle but havent had time to look any further into it.
|