2009 acura tsx, alarm/remote start
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=107007
Printed Date: July 04, 2025 at 6:21 AM
Topic: 2009 acura tsx, alarm/remote start
Posted By: dazzler
Subject: 2009 acura tsx, alarm/remote start
Date Posted: August 24, 2008 at 3:50 PM
Would like to install a AutoStart combo and could not find a current wiring diagram .The 2004-2008 diagram do not match the wiring in the 2009.
Replies:
Posted By: chriswallace187
Date Posted: August 25, 2008 at 1:53 PM
Wire Description Color Polarity Location
12V constant White + Ignition Harness
Starter Yellow + Ignition Harness
Ignition Blue + Ignition Harness
Acc. Orange + Ignition Harness
Acc. 2 Red + Ignition Harness
Parking Lights Gray - Light Switch Harness
Horn ORANGE / Silver dots - 10 pin connector top of column
Tach All of these can apparently be picked up with a data module
Brake
Lock
Unlock
Factory Arm
Factory Disarm
Trunk Release
Door Trigger
Trunk Trigger
Hood Trigger
Immobilizer Most likely hasn't changed - Bypasskit PKH34 will work
Also the XK05 with the PKH4 firmware
If for whatever reason you need the analog wire colors for the stuff that's done by data let me know.
-------------
C Renner's Auto Electronix
My service is cheap, quick, and good - pick any two
Posted By: Chris Luongo
Date Posted: August 25, 2008 at 4:01 PM
I've done a couple, and the colors Chris mentions sounds right.
The modules from idatalink.com will give you a lot of time-saving outputs. You won't have to run wires under the hood, or inside the door, and you won't have to give up your valet key.
If you do buy one of their modules, it needs a special firmware for that car or it won't work. Make sure whoever you buy from will sell it to you with the correct firmware already in it.
Posted By: dazzler
Date Posted: August 25, 2008 at 7:21 PM
Thank You very much, the wires look right and I was going to do it without a data module but I will take your advice and pick up a data module. Thank You again!
|