viper alarm issue
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=107017
Printed Date: May 14, 2025 at 2:44 AM
Topic: viper alarm issue
Posted By: boofin
Subject: viper alarm issue
Date Posted: August 24, 2008 at 11:41 PM
I have a viper 690xv alarm on a 92 honda accord. When the alarm is armed and I open the door my remote shows "door" just as it should. Then when I hit unlock it shows "door," letting my know my door was opened. I then arm my car again, I DONT open the door and hit unlock and it still shows "door" even though the door has not been opened since the previous time. What causes this? Thanks
Replies:
Posted By: kgerry
Date Posted: August 25, 2008 at 10:54 AM
did you cycle the ignition to clear the "event memory"?
-------------
Kevin Gerry
Certified Electronics Technician
MECP First Class Installer
Owner/Installer
Classic Car Audio
since 1979
Posted By: boofin
Date Posted: August 25, 2008 at 2:36 PM
No I dont think I did. I only have my door trigger, door unlock/lock hooked up. Which is the way I want it. So if I hook-up the ignition wire to the cars ignition it clears the memory? Thanks
Posted By: howie ll
Date Posted: August 25, 2008 at 3:31 PM
If you don't hok the yellow? ign input to ign, a) It won't recycle as above and B) You're alarm will work even with ign ON. Very embarrasing for you if you made an immobiliser cut.
Posted By: boofin
Date Posted: August 25, 2008 at 4:59 PM
Well I hooked up the ignition input and thats solved the probelem. Thanks guys!
|