dei xk01
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=107357
Printed Date: July 14, 2025 at 9:31 AM
Topic: dei xk01
Posted By: nbcadillac
Subject: dei xk01
Date Posted: September 10, 2008 at 4:07 PM
i installed a compustar 2 wshled-s 2-way remote start on a 01 cadillac deville dhs and used the dei xk06 for the door locks and a dei xk01 for the passkey 3. the copmustar and the xk06 work fine my problem is the xk01. after hooking it up when i plug it in the led is susposed to turn on for 2 sec then go off. well the led just stays on. it has been flashed for my car and i tried to reset the xk01 with no luck. anyone have any ideas?? thanks
Replies:
Posted By: craig dennis
Date Posted: September 11, 2008 at 1:20 AM
to reset it u have to reflash it thats the only way other than that its late here so ill read again in the morning and see if i can be of more help
Posted By: megaman
Date Posted: September 11, 2008 at 8:54 AM
If it won't reset with the standard method which is pressing the program button while inserting the harness, then you'll need to reflash the firmware. I've had a few of the xk01's not program, but after the reset method, they worked fine. Just make sure you continue to press the program button, then insert the harness, and wait until it flashes rapidly before you let go of the program button.
Posted By: kgerry
Date Posted: September 12, 2008 at 9:18 AM
also, don't let go as soon as it starts flashing... hold it for about 4 seconds and you'll hear a click from the module...then it's ready to go....
-------------
Kevin Gerry
Certified Electronics Technician
MECP First Class Installer
Owner/Installer
Classic Car Audio
since 1979
Posted By: Chris Luongo
Date Posted: September 12, 2008 at 8:25 PM
The XK01 should do everything on that car. Shouldn't need the XK06 at all.
By the way, the XK06 doesn't do locks anyway. It's for transponder bypass only in newer GM cars.
It's possible that maybe having the two modules in there at once is what's not letting you program the XK01.
Also, where is the purple wire from the XK01 connected in the car?
Should be connected to the purple databus wire in the car. You could catch the data wire almost anywhere you want (it runs all over the car, to various modules), but the easiest would be right at the OBDII diagnostic plug under the dash.
Posted By: nbcadillac
Date Posted: September 13, 2008 at 10:32 AM
Thanks for all of the help. I just took it back to the shop that sold me the starter and modules and had them install it. So, not everything works as it should..
Posted By: nbcadillac
Date Posted: September 13, 2008 at 10:47 AM
I meant now, everything works as it should..
|