Print Page | Close Window

viper 560xv problems

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=107501
Printed Date: May 14, 2024 at 12:42 AM


Topic: viper 560xv problems

Posted By: unclebeaner
Subject: viper 560xv problems
Date Posted: September 17, 2008 at 1:32 AM

hi im new to the site and like it so far, i took the said viper system out of my chevy truck due to it being wrecked. i installed in into a 98 jeep cherokee. everything works great thanks to your banks of knowledge lol. no problem now is the siren will not stop sounding. constant power coming out of brown wire. any thoughts?anyone else have this issue? thanks in adavnce brandon

-------------
i break everything



Replies:

Posted By: albertatech
Date Posted: September 26, 2008 at 6:57 PM
Can you please list the connections you have made? Please be specific  including tracer colors (ie. Pink/white is a pink wire with a white stripe) and where the wires are (ie. ignition harness or describe the harness from the remote start system). This will allow troubleshooting as to which is misconnected. thx :)




Posted By: unclebeaner
Date Posted: September 26, 2008 at 11:00 PM
i used the install guide i downloaded from here and i use bullydogsecurity.com for connection points

-------------
i break everything




Posted By: albertatech
Date Posted: September 27, 2008 at 5:03 PM

Ok well I copied and pasted that site and got nothing from it other than it being a phishing site. Here is what I have for that model for vehicle connection points.

1998 JEEP CHEROKEE WIRING DIAGRAM SCHEMATIC

+12VDC            +      RED & PINK/BLACK               IGNITION HARNESS

STARTER         +      YELLOW                                   IGNITION HARNESS

IGNITION 1       +     DARK BLUE                             IGNITION HARNESS

IGNITION 2       +     BLACK/ ORANGE                    IGNITION HARNESS

ACCESSORY   +     BLACK/ WHITE                        IGNITION HARNESS

LOCK     -      ORANGE / PURPLE      DRIVER KICK PANEL, MUST USE RELAYS, TEST WITH DOORS CLOSED

UNLOCK     -    PINK/PURPLE         DRIVER KICK PANEL, MUST USE RELAYS, TEST WITH DOORS CLOSED

PARKLIGHTS  +      BLACK / YELLOW                     HEADLIGHT SWITCH

BRAKE              +      WHITE/ TAN                             BRAKE SWITCH

TACH                 AC    GREY                                      BLACK PLUG AT PCM  Notes: The PCM (powertrain control module) is located on the drivers side inner fender well near the radiator support.

HORN                -        BLACK/ RED                          STEERING COLUMN

DOOR PIN        -        YELLOW                                 DRIVER KICK PANEL IN GREY 2 PIN CONNECTOR

Are these the same as what you have connected?






Print Page | Close Window