2008 tacoma shifting trouble

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=107555
Printed Date: May 12, 2025 at 2:55 PM

Topic: 2008 tacoma shifting trouble

Posted By: Memphisman
Subject: 2008 tacoma shifting trouble
Date Posted: September 19, 2008 at 7:59 PM

Yesterday I installed a RS into a 2008 Tacoma. Work fine when it left the shop. Today the customer brought it back and said that the check engine light is on and that the tranny won't engage like it should-it will stutter for a few seconds and then engage. He said it shifts like it should after it engages. I followed my wiring diagram and checked every wire since this was my first new style Tacoma. Any suggestions?

Replies:

Posted By: KarTuneMan
Date Posted: September 19, 2008 at 8:27 PM

Both ignitions, both starters... ?

Posted By: i am an idiot
Date Posted: September 19, 2008 at 8:34 PM

Disconnect the coil of relays one at a time. There is a wire in that vehicle that does not like having a relay connected to it.

Print Page | Close Window