07 audi a3 remote start

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=107566
Printed Date: May 14, 2025 at 2:00 AM

Topic: 07 audi a3 remote start

Posted By: vince954
Subject: 07 audi a3 remote start
Date Posted: September 20, 2008 at 8:36 AM

I am installing a Clifford 70.5x remote start system in a 2007 Audi A3, I will be using their CAN1 can bus interface and an inmobilizer bypass but does anyone have the connections for remote start?

Replies:

Posted By: cutter1122
Date Posted: September 20, 2008 at 5:35 PM

12v Constant: RED / BLUE + AT VESCM UNDER DRIVER SIDE DASH IN 8 PIN BLACK CONN.

Starter 1: RED + AT IGNITION HARNESS

Ignition 1: YELLOW + AT IGNITION HARNESS

Ignition 2: BLUE + AT IGNITION HARNESS

Accessory 1: GREEN + AT IGNITION HARNESS

Brake switch: BLACK / YELLOW + AT SWITCH

Hand Brake: BROWM / YELLOW - AT SWITCH HARNESS

Posted By: vince954
Date Posted: September 20, 2008 at 5:48 PM

thanks, that should help... I will have to figure out how to get into the harness as the steering columm module is mounted right below the ignition switch and there is no obvious way to see the connections betwen them...

Posted By: vince954
Date Posted: November 04, 2008 at 8:38 AM

would you happen to have the connections for lock/unlock. I have a can interface but its not reliable for this funciton for some reason