Print Page | Close Window

car only starts with remote starter

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=107892
Printed Date: June 07, 2024 at 10:34 PM


Topic: car only starts with remote starter

Posted By: alscrx
Subject: car only starts with remote starter
Date Posted: October 02, 2008 at 9:54 PM

Guys, recently i have not been able to start my car via the key in the ignition!  I turn the key and i get nothing, as though the starter is killed. I have a security keypad hooked up with my galaxy 8000rs alarm. I had no problems till recently. So i replaced the 2 relays i seen that control the keypad and remote start and still does the same thing. When i enter the code on the keypad i hear the relay click so i think thats working. I have a toggle switch hooked up to the keypad and even when its off i still can't start her up with the key.

I am however,able to remote start the car with no problem. Kinda sucks every time i wanna get in and go i got to remote start the car.

What could be causing this?




Replies:

Posted By: i am an idiot
Date Posted: October 03, 2008 at 5:11 AM
The only thing I can think of is a bad connection from the ign. switch to the point that the remote start connects to the start wire.  Or a bad ign. switch.




Posted By: kgerry
Date Posted: October 03, 2008 at 11:52 AM
DID YOU HOOK UP ANTI-GRIND?     i have had a few of the DEI XCRS relay packs anti-grind relays latch... which give you the exact same problem.... just a thought.....

-------------
Kevin Gerry
Certified Electronics Technician
MECP First Class Installer

Owner/Installer
Classic Car Audio
since 1979




Posted By: alscrx
Date Posted: October 04, 2008 at 11:12 PM

kgerry wrote:

DID YOU HOOK UP ANTI-GRIND?     i have had a few of the DEI XCRS relay packs anti-grind relays latch... which give you the exact same problem.... just a thought.....

I don't remember if i did. I did the install awhile ago. So what was your resolution to the relay packs latching??





Posted By: kgerry
Date Posted: October 06, 2008 at 1:32 PM
tap on it with a screwdriver... i'll unlatch... or replace it......

-------------
Kevin Gerry
Certified Electronics Technician
MECP First Class Installer

Owner/Installer
Classic Car Audio
since 1979




Posted By: alscrx
Date Posted: December 26, 2008 at 9:26 PM
well so you guys know it was the ignition switch itself.





Print Page | Close Window