clifford siren

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=108045
Printed Date: May 14, 2025 at 2:56 PM

Topic: clifford siren

Posted By: markmills2000uk
Subject: clifford siren
Date Posted: October 09, 2008 at 3:12 PM

iv got a clifford 950 intelliguard and my clifford siren died,i bought a new battery back up alarm but cant seem to sire it in right,comeing from the brain i have black red green and yellow,anyone know which wire does what,cheers

Replies:

Posted By: howie ll
Date Posted: October 09, 2008 at 4:19 PM

They join to the same colours in the alarm. It's a half hour job. Remove 1amp fuse from holder at alarm CPU and either follow through with lead to oeiginal plug or cut and solder join, replace fuse.

Posted By: markmills2000uk
Date Posted: October 10, 2008 at 11:31 AM

its not that simple for me as my new siren is not a clifford one,its got black and red which are permenant live nad negative,then white and yellow which are signal on plus and negative,iv but a tester on the clifford loom to see which is which but cant seem to get it to work,the red and black from the clifford are permanent live and negative but i cant figure out the yellow and green from the clifford as they both seem to be positive,the one puts out 4 volts all the time and the other one i have not figured out yet