data buss module?
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=108058
Printed Date: May 11, 2025 at 6:55 PM
Topic: data buss module?
Posted By: hum dinger
Subject: data buss module?
Date Posted: October 09, 2008 at 10:30 PM
Hey guys, I got an '03 H2 I am putting a 791 viper in. I was going to use a Directed 1700g because I heard it is the best one that does almost everything but they are now discontinued. Is there another model or brand I should look at that does everything the 1700g does or more?
Replies:
Posted By: brhaugen
Date Posted: October 09, 2008 at 10:43 PM
Get the XK01.
The only difference is it is reprogrammable for many more makes and models.
It does come standard with the firmware for your truck.
-------------
Brent Haugen
Fargo, ND
Posted By: Chris Luongo
Date Posted: October 10, 2008 at 6:41 AM
I agree.
The XK01 is easy to install, and even activates your heated seats and rear defroster automatically when it's cold out.
The GMDLBP is a little less expensive, doesn't do the heated accessories, but it adds a Panic feature.
www.idatalink.com and www.ifar.ca also have modules that will work for you.
In any case, read the install manual before you buy. That'll help you make a better decision.
Posted By: hum dinger
Date Posted: November 01, 2008 at 9:26 PM
Hey guys looking to find a few wires. 1: Neutral safety. Probed around the wires by the selector but couldn't find one. 2: Heated seats. I assume they are on one of the BCM plugs. I would like to wire in so I can turn them on remotely. Will this cause problems when the XK01 tries to turn them on automatically when its 32 degrees out? 3: Rear defrost. same as above.
Posted By: brhaugen
Date Posted: November 01, 2008 at 10:09 PM
1) Shouldn't need Neutral Safety
2 and 3)The XK01 does these automatically when you remote start --- why would you need to activate them any other time??
-------------
Brent Haugen
Fargo, ND
Posted By: hum dinger
Date Posted: November 02, 2008 at 1:06 AM
I heard it only does the defrost and seats when the temp is 32 degrees and I would like to maualy/remotely turn them on if it's 40 degrees etc.
Posted By: hum dinger
Date Posted: November 02, 2008 at 1:13 PM
Also do I need to use the hood pin wire or does the xko1 monitor that and set off the alarm through the data bus?
Posted By: kgerry
Date Posted: November 03, 2008 at 10:05 AM
you need the hood pin....
-------------
Kevin Gerry
Certified Electronics Technician
MECP First Class Installer
Owner/Installer
Classic Car Audio
since 1979
|