562t remote starter does not crank

I have 562t remote starter and installed to my 2003 camy but my vehicle starter does not crank when I push start button on my remote key. Also when using remote doors can lock only, unlock button can not unlock doors.  My connections are followling ( I don't know it is right since this is my first time) if any one can hlep me please.

  PRIMARY HARNESS (H1):

- RED / white (-) 200mA channel2 Output: to trunk wire with relay( this worked).

- Black Ground Input: to chassis ground.

- White (+/-)Parking light output: directly to Green wire (+) of 2003 camry. ( this worked).

- WHITE/ Blue(-) activation Output and Blue (-) 2nd unlock Ouput: these wires I dont know , WHITE/ Blue wire confused me with Gray(-) Hoodpin Shutdown Input from Remote Harness H3/4.

The Orange (armed), BLACK/ white( domelight), Brown( horn), Green and Violet are not used since I don't need these.

Auxiliary Harness ( H2): not used

 Remote Harnesss(H3):

- Brown (+) Brake Shutdown: to brake wire of vehicle

- BLACK/ White neutral safety Input: one end to toggle switch, the other end to ground.

-  Blue/White 2nd status/defogger: not connected yet

- Gray (-) hoodpin shutdown: connected

- Violet/White Tach input: not connected yet ( dont know if remote starter cannot crank because of not connecting this wire? ).

Door Lock H4:

 - Blue and Green are connected to (-)Blue and (-)Blue / YELLOW in vehicle

This can only lock doors, but cannot unlock doors. I don't know why.

  Relay satellite Wiring:

  - Blue (status), Orange (ACC), Violet (starter output) and Pink(3rd ignition): not used

- Heavy Guage Wires:    -  Purple to the starter side.

                                    -  Green to the key side

                                    - Orange : not connected yet

                                    - Pink to ignition of vehicle

                                    - Pink/White to 2nd ignition of vehicle

                                   -  All 12v Constant Input are connected

I  wonder if I need to connect the second starter wire and How ?

My remote button cannot unlock doors and cannot start ( even the lights are on and off just like igntion on and off when I hit the start button). Please help me

Thanks

how can I connect the second starter wire?

I think (but not sure) the module is already in double pulse for unlock because the Green wire reads around 14V twice when I hit the unlock button on the remote.

Please help

thanks

double, double check that, because it sure sounds like your not set for a double pulse. either that or you have the wrong wire. the 562T has a wire that is a negative pulse start. using a relay connect that wire to term 86, connect term 85 to 12v constant, connect term 30 to 12v constant, connect term 87 to your second starter wire.

Thanks for your help Ckeeler, i will check the doors again. However, instead of a negative pulse start for connecting to second starter wire ( using relay as you recommended) the Violet (starter output) from 562t come out with 14V. This make me confused and then I disconnected other wires connecting to the Relay satellite, just connect the 12v constant input to it . The signal of Violet ( starter ouput) still 14V .

I dont know why ?????

Thanks Ckeeler, Finnaly my RS works but only with the key in the Ignition. Does My 2003 camry needs a transponder module for RS to work ?. what kind of transponder do you suggest ?.

DEI 556U  is good for my 2003 camry ?

thanks .