91 camry, door lock, viper 160xv

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=108571
Printed Date: May 10, 2024 at 5:16 AM

Topic: 91 camry, door lock, viper 160xv

Posted By: itmero
Subject: 91 camry, door lock, viper 160xv
Date Posted: October 31, 2008 at 4:38 PM

hi dudes and dudettes,

I am newbie here and asking for help in installing the door lock in my 1991 toyota camry V6. My unit is a viper 160XV and its remote starter and other functions are already working except for the lock/unlock features. this is what i know so far.

1) wires on the door lock harness - light blue and green

2) the lock wire on my car is light green

3) unlock wire on my car is dark green.

QUESTION:

1) how should i connect the four (4) given wires?

2) do i still need a relay to interconnect these wires?

3) what is techtips 1041? from the previous posts, i cannot access the directtechs 1041.pdf site.

please help me.

thank you very much for your time.

-------------
BSURSUCSIMIM
Raja Daremoj

Replies:

Posted By: i am an idiot
Date Posted: October 31, 2008 at 5:42 PM

According to the Audiovox site, the colors of the wires on the car are as follows. You should not need a relay to connect to these wires.

	Power Unlock		GREEN/ RED		(-)		DRIVERS KICK PANEL
	PowerLock		LIGHT GREEN		(-)		DRIVER'S KICK PANEL

Posted By: itmero
Date Posted: October 31, 2008 at 6:26 PM

thanks bro but how do i connect the viper wires to these lock/unlock wires? cut these wires and connect the viper wires or interconnect these wires? thanks again

-------------
BSURSUCSIMIM
Raja Daremoj

Posted By: i am an idiot
Date Posted: October 31, 2008 at 6:46 PM

You just need to connect the wire from the alarm to the wire of the car. Remove a small section of the insulation, twist the alarm wire around the exposed piece of wire, solder it and insulate it. Or cut it strip it, slide a piece of heat shrink tubing over the wires, Solder them and cover the joint with the heat shrink, shrink it.