command start programing

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=108585
Printed Date: May 16, 2024 at 2:24 PM

Topic: command start programing

Posted By: cdnemsguy
Subject: command start programing
Date Posted: November 01, 2008 at 11:47 AM

I cannot get the command start to go into programming mode. I pull the hood switch to ground, lights on for 3 seconds, then bump hte switch , get the lights again, bump the switch again but the lights will not stay on to indicate it is in the program mode. Am I doing something wrong here? Please help.

Replies:

Posted By: cdnemsguy
Date Posted: November 01, 2008 at 4:24 PM

I found the antenna had got disconnected so after plugging that it, all works well. The only thing I need to find now is what settings are in the box.

Print Page | Close Window