First off I'm using the 556U bypass, is that right.
Second with the wiring Everything but RS works. I'm able to do the Remote start sequence. Then I when I try to RS I don't even get the starter noise. The parking light flash 5 time as the error code. Thats brake shut down input active. Well I stayed in the car with my meter on the brake wire and its not giving 12v. so im stumped.
Do I need to use 2nd acc, or ign?
My detail install below
H1 harness:
- RED / White aux trunk release-nothing
- red 12V constant- wired to power
- Brown Siren - wired to red wire on siren
- WHITE/ Brown (flex parking light relay) - not used
- Violet door - none - don't really know
- Blue trunk - trunk wire off forget which
- Green Door - input (-) got it
- BLACK/ white domelight 200mA - none This I don't need because if the door is unlocked the domelight turns on?Y/N
- WHITE/ Blue remote start activation (-) input - nothing
- White parking light - got it
- Orange ground-when-armed - none
NSS is pluged and in the ON position-
Remote Start in harness ( 5 wires )
- BLACK/ white - I grounded it
- Violet/white - I used the blue wire next to the battery
- Brown brake for shut down - Igot it
- Gray hood pin - Normally open - did it
- Blue/white 2nd remote start or rear defogger - I wanna use as a rear defogger, Do I need a relay? If not just direct wire to it.
Door locks are set
H 2 harness out of the 8 wires looks like I only need horn honk. I has 3 AUX, 2 OEM arm/Disarm, 2nd unlock, Wait-to-start.
Now the R/S output harness- I didn't use a single wire yet but here they are. If any of these are for the 556 U let me know
- blue RS status(-) THIS IS THE ONE I CONNECT TO BLUE ON 556U
- Pink RS ignition (-)
- Violet RS starter(-)
- Orange RS accessories(-)
- Pink/White flex-
H3 harness the power wires. I wired the 4 out of the nine. colors car codes
- 12v - white
- ignition - BLACK / YELLOW
- Starter - BLACK/ white
- accessory BLACK/ red - is second acc needed.(WHITE/ red) I didn't wire it.