keyless entry not working with polar star
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=108953
Printed Date: October 31, 2024 at 6:07 PM
Topic: keyless entry not working with polar star
Posted By: linedriver
Subject: keyless entry not working with polar star
Date Posted: November 15, 2008 at 11:44 PM
i installed a polar start PS-7450-TW-FM not too long ago on my 1990 nissan skyline. i just installed the door lock actuator today and found out that it doesnt seem to want to work.
i tested out the wires leading to the actuator with a DMM and it rests at 0V, and when i press lock and unlock, it goes to +12V and -12V, so it is getting the correct power to the actuator as far as i can see, yet it still does not want to operate at all.
is there anything else i can try to do before i take it in for repairs, or possibly try another actuator? since this is a brand new actuator, i cant see it being the problem, but i am kinda uncertain about it because the DMM readings were pretty much right for a 2 wire actuator.
Replies:
Posted By: Velocity Motors
Date Posted: November 16, 2008 at 10:55 AM
How did you wire up the relays for the actuator ? It should be like this : https://www.velocitymotorsport.com/images/install_notes/104.jpg ------------- Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA
Posted By: linedriver
Date Posted: November 16, 2008 at 12:18 PM
the diagram i used was here:
https://www.the12volt.com/doorlocks/page3.asp#4w
i used the Actuators / Reverse Polarity diagram
Posted By: linedriver
Date Posted: November 16, 2008 at 6:13 PM
got the locks to work finally. turns out the actuator was defective
|
