clifford avant4 install help

Im going to start installing the alarm tomorrow and i have a couple of questions right off the bat.  This is probably just the first of many so I would like to thank everyone in advance for there help.  My problem is his: when wiring up the intellistart 4 unit I see i need 6 wires (plus the 2 battery leads) they are the ignition, starter, accessory, heater/ac, heater2, ignition2. with a note on heater2 and ignition2 "as required"  Now this is going on a 97 chevy full-size pickup.  according to my wiring diagram i have these wires available. starter(brown) iginition(pink) ignition2(white) ignition3(brown) and accessory(orange).  well that leaves me with the predicament of which wires to connect to what.  More specifically what do i connect the following alarm leads to? heater/ac, heater2 and ignition 2.  Ignition2 is easy i'll just connect that to the second ignition wire on the truck its the heater/ac and heater2 wires on the alarm that has me at a loss.  I hope that was a decent description of my problem. once again thanks for the help,

Taylor

I have listed the wires that you need to tab into below. Just take the wires from the Intellistart4 and wire to the appropriate wires from the diagram below.

|       ITEM      |     WIRE COLOR     |POL|       WIRE LOCATION        |
|              12V|red                 |+  |ignition harness            |
|          STARTER|yellow or purple    |+  |ignition harness            |
|         IGNITION|pink                |+  |ignition harness            |
|  SECOND IGNITION|white *5            |+  |ignition harness            |
|   THIRD IGNITION|pink/white *1       |+  |ignition harness            |
|        ACCESSORY|orange              |+  |ignition harness            |
|       POWER LOCK|lt. blue            |*2 |either door boot            |
|     POWER UNLOCK|white               |*2 |either door boot            |
|       LOCK MOTOR|gray                |   |drivers kick panel          |
|     UNLOCK MOTOR|tan                 |   |drivers kick panel          |
|    DISARM DEFEAT|tan                 |   |passengers kick panel       |
| PARKING LIGHTS +|brown               |   |switch or fuse panel        |
|       HEADLIGHTS|yellow              |+  |at switch                   |
|     DOOR TRIGGER|purple or ppl/wht   |-  |light switch                |
|       TACHOMETER|white *3            |   |ECM *4                      |
|       BRAKE WIRE|white               |+  |at brake pedal switch       |
|     HORN TRIGGER|black               |-  |at column                   |
|           WIPERS|purple              |+  |steering column             |
|  LF WINDOW UP/DN|dk. blue - brown    |A  |at drivers door switch      |
|  RF WINDOW UP/DN|light blue - tan    |A  |drivers door or boot        |
|  LR WINDOW UP/DN|green - purple      |A  |drivers door or boot        |
|  RR WINDOW UP/DN|lt. grn - pur/wht   |A  |drivers door or boot        |

Notes:
*1 The pink/white does not exist on all models.   *2 5 wire (type C) on the two door models, and positive trigger (type A) on the four door and keyless entry models.  *3 Tach wire on the 6.5 Diesel is white at the instrument cluster. Diesel wait to start wire is dk. blue (-) located at the instrument cluster 'see directfax document #1090'.  *4 ECM located on drivers side inner fender well. Two plugs, white wire in plug marked 'white'.  *5 Make sure to enable second ignition wires for remote starts to prevent possible transmission damage and the check engine light from coming on.