04 acura tsx ignition

this is the tech info i get from audiovox's tech website!

Battery		WHITE		(+)		IGNITION SWITCH HARNESS
	Ignition 1		BLACK / YELLOW		(+)		IGNITION SWITCH HARNESS
	Ignition 2		BLACK/ RED		(+)		IGNITION SWITCH HARNESS
	Accessory 1		WHITE/ RED		(+)		IGNITION SWITCH HARNESS
	Starter 1		BLACK/ WHITE		(+)		IGNITION SWITCH HARNESS
	Anti-Theft Type		IMMOBILEIZER
	Anti-Theft Descript		TRANSPONDER
	Key Sense		(RED / WHITE)		(-)		IGNITION SWITCH HARNESS
	Tachometer		RECOMMENDED TO USE AN INJECTOR		(AC)		AT PCM MODULE IN FRONT OF CENTER CONSOLE UNDER DASH
	Crankshaft Sensor		BLUE		(AC)		AT ECM MODULE IN FRONT OF CONSOLE UNDER MIDDLE OF DASH
	Camshaft Sensor		BLUE/WHITE		(AC)		AT ECM MODULE IN FRONT OF CONSOLE UNDER MIDDLE OF DASH
	Speed Sense		(BLUE/WHITE)		(AC)		AT ECM LOCATED BEHIND CENTER CONSOLE BELOW RADIO
	Parking Lights		RED / BLACK		(+)		LARGE PLUG IN DRIVER'S KICK PANEL
	Low Crr. Pk Lights		(BLACK/ RED OR BLUE/RED)		(-)		STEERING COLUMN HARNESS
	Brake Lights		WHITE/ BLACK		(+)		AT THE SWITCH ABOVE THE PEDAL
	Reverse Lights		(GREEN)		(+)		DRIVERS SILL PLATE HARNESS TO REAR OR CAR
	Horn		(GREEN/ YELLOW)		(-)		STEERING COLUMN HARNESS

	< color=#3a437f>Note: Audiovox makes no representation or warranty with respect to the above information including its accuracy, completeness, or its freedom from third parties' proprietary rights. Audiovox disclaims all liability or responsibility for errors or omissions therein or any decision made by the recipient in reliance thereon. The installer must verify any circuitry with the proper test equipment prior to installation.

-------------
...half of the truth can be worse than a lie. <----Roger Russell said that..

After you get the steering column cover apart (which is difficult to do without breaking it, because Honda designed it poorly, but it's cheap to replace!):

Close to the keyhole there will be two green plugs.

One of the plugs will have more pins than the other one, and also the wire colors will be different in each plug.

You should be able to just look at the instructions for the bypass module, and pick the plug that has the right amount of pins, and the right wire colors.