hornet 727 sentra 2008
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=109221
Printed Date: June 06, 2024 at 9:28 AM
Topic: hornet 727 sentra 2008
Posted By: alex98
Subject: hornet 727 sentra 2008
Date Posted: November 24, 2008 at 11:59 PM
I have problems conecting the Green for arm input, Red disarm defeat input and the Blue disarm input. According to the instructions i need to connect the Green to the lock wire, the Blue to the unlock and the Red also to the unlock wire. I connected the input wires to the unlock and lock wires at the door harness. When I try to program the learn lock/unlock routine I get as far as step 6 and when I press the lock button on the remote the LED flashes for about 2 times and the alarm honks the car and exits the learn routine. I close all the doors for programing and have all other inputs at rest. I'm not sure if my problem is that I need to connect the wires close to the switch and not at the door harness. Also I'm not sure where exactly to connect the Red wire. I am installing the system in a 2008 Nissan Sentra with remote keyless entry. Any help would be greatly appreciated.
-------------
alex
Replies:
Posted By: alex98
Date Posted: November 30, 2008 at 6:17 PM
I figured out the problem. I connected the arm and disarm wires to the motor wires instead of the lock/unlock wires from the switch. Afterwards it was ver easy to program and install. Thanks anyways.
-------------
alex
|