2002 accord, security, remote start
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=109255
Printed Date: April 30, 2024 at 2:54 AM
Topic: 2002 accord, security, remote start
Posted By: ervie
Subject: 2002 accord, security, remote start
Date Posted: November 26, 2008 at 9:36 AM
I am having problems getting the security to to disarm while remotestarting. The problem is it seems to only does some times. Anyway my question is for my lock and unlock wires i have going to the orange and blue/black, so i did a search and found out you can use your arm and disarm wires here aswell. So do i need to use diodes
Replies:
Posted By: KarTuneMan
Date Posted: November 26, 2008 at 10:30 AM
Behind the glove box in a green plug is a yellow wire. The plug is labeled G The yellow wire is the ign. feed TO the security system. You need to "open" this wire with a relay, triggered with ground while running. Cut the wire and put the plug side of the wire to pin 30, and the other half on pin 87a. 12V to 86, and ground while running to 85. -------------
Posted By: ervie
Date Posted: November 26, 2008 at 1:09 PM
no other way huh!!!!!!!
Posted By: KarTuneMan
Date Posted: November 27, 2008 at 3:08 AM
Uhm.... no. I really cannot think of an easier way. I am however, open to suggestions. -------------
Posted By: ervie
Date Posted: November 27, 2008 at 7:55 PM
what do you think would happen if i hooked up the arm and disarm wires to cars lock and unlock wires
Posted By: jar754
Date Posted: November 27, 2008 at 10:14 PM
stupid question but did you hook up the fasd wire
Posted By: ervie
Date Posted: November 28, 2008 at 9:31 AM
ah what is fasd wire
Posted By: jar754
Date Posted: November 28, 2008 at 10:16 AM
factory alarm shutdown wire, its blue(-) on ex model is located at the power window switch, and lx is at the keyless/security module attached under drivers dash panel. not sure what color it is on ur rs unit cuz i dont know which unit u have, it allows u to keep factory alarm with aftermarket units
Posted By: mobile1
Date Posted: November 30, 2008 at 12:35 AM
ervie] wrote:
what do you think would happen if i hooked up the arm and disarm wires to cars lock and unlock wires
you can do this no problem. The way you hook it up would depend on the remote starter. You can tap you disarm wire into your unlock output on your R/S and hook that up to the unlock wire in the car. This will unlock the car, however after you remote start the car. You would then have to relock the car after it starts. Some R/S units have a programming option to lock after start, some don't. If it doesn't, you will have to use either a (-) starter output with a diode inline from the R/S brain to your lock wire, or the 12v+ starter output with relay to change the polarity to (-) and hook that up to your lock wire. This way, once you remote start the car, it will relock the doors.
|