tach programming, no start

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=109522
Printed Date: May 17, 2025 at 3:10 AM

Topic: tach programming, no start

Posted By: rfwave
Subject: tach programming, no start
Date Posted: December 06, 2008 at 12:28 AM

autostart AS-2461-TW-FM into 92 eagle vista .

i've never experienced something happened like this one ;

when i was programmed tach and realized there was an error ,but i kept go on (followed procedure ) , i started the car with key . the car wont crank , i only heard some ZZZZ...noises .( car starter in good condition ) .

is it possible that the RS can prevent the current flow to starter of the car ??? . ( no starter kill ) .

thank you .

Replies:

Posted By: rfwave
Date Posted: December 06, 2008 at 10:11 PM

why ? this is a tough ? for me .

Posted By: i am an idiot
Date Posted: December 06, 2008 at 11:01 PM

Does the starter turn the engine over at all? When you connected the starter wire from the remote start unit, did you cut the car's starter wire, and it possibly came apart when you spliced it back together?

Posted By: rfwave
Date Posted: December 08, 2008 at 1:17 PM

no , engine didnt turn over at all , it sounds like a very weak battery , ( but it is a new batt ) . at first i wanted to install starer kill , i did cut the stater wire , then i changed my mind and reconnected .

as you said it possibly came apart . i will double check it in a warmer days ,right now its too cold outside .

thanks " idiot " .

Posted By: i am an idiot
Date Posted: December 08, 2008 at 6:26 PM

Did you check the battery voltage while attempting to start?

Print Page | Close Window