01 cavalier, remote start/keyless

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=109544
Printed Date: November 10, 2024 at 1:58 PM

Topic: 01 cavalier, remote start/keyless

Posted By: dksob81
Subject: 01 cavalier, remote start/keyless
Date Posted: December 06, 2008 at 7:30 PM

I am installing a Remote Start/keyless entry on a buddy car. I got around the PASSLOCK II security system but I cannot figure out how to wire the keyless entry part. From what I have read this system is TYPE A (factory Keyless entry) which is positively triggered, so i connected the positive unlock/lock wires from the system to the White wire and Lt. blue wire in the driver kick panel and when I try to remote lock or unlock nothing happens. Do I have this connected right?

Joe

Replies:

Posted By: xplorin16
Date Posted: December 06, 2008 at 10:53 PM

What kind of rs/keyless. The positive output may not be strong enough to power the locl/unlock. You may need to use relays to increase the current going to the lock/unlock wire.

-------------
Advanced MECP

Posted By: chriswallace187
Date Posted: December 07, 2008 at 12:25 AM

Equally as important, did you meter the wires? There are multiple blue and white wires in the DKP, most of which have nothing to do with door locks.

-------------
C Renner's Auto Electronix
My service is cheap, quick, and good - pick any two

Print Page | Close Window