Print Page | Close Window

2005 4door dodge neon wiring and clamp

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=109778
Printed Date: May 28, 2024 at 7:49 PM


Topic: 2005 4door dodge neon wiring and clamp

Posted By: ajan246
Subject: 2005 4door dodge neon wiring and clamp
Date Posted: December 15, 2008 at 7:42 PM

Ok i'm doing an install on a 2005 4 door dodge neon. I'm putting in aftermarket actuators (DEI's) and an ASTRA 600. I looked at some wiring diagrams for the car and it looks like it only has trigger wires for the two front doors, but what about the rear doors? Do they run on the same trigger wires? The diagram tells me to diode isolate the trigger wire which is fine but if all 4 doors run on 2 trigger wires do I need 4 diodes or 2?

Also I ran into a bit of a problem with my actuator clamps. The door rod on the neon is far to thick for my clamp to fit on there to secure it to the actuator rod. Any other ideas on what i can use? Some type of different clamp of some sort? (I aint welding it).


Thanks in advance,
-Ajan246



Replies:

Posted By: jseibold
Date Posted: December 15, 2008 at 9:08 PM
LF LatchTAN(-)IN HARNESS IN DRIVERS KICKPANEL
posted_imageRF LatchBLUE/ORANGE(-)IN HARNESS IN PASSENGER KICKPANEL

Blue/orange should cover all doors except drivers so you only need 2 diodes total.  on the actuators i've used a split bolt.  its just a nut and bolt but it has a slot in it so you slide it on the factory rod and the actuator rod and then tighten the nut so it "sandwiches" together nice and tight.  good luck



-------------




Posted By: ajan246
Date Posted: December 15, 2008 at 11:29 PM
ahh! You're a genius! So hard trying to find something that works! Googling things like actuator connector and things like that! Genius! Does a homedepot or Lowes carry something like that? or do I need to go to an electrical supplier?




Posted By: jseibold
Date Posted: December 16, 2008 at 9:33 PM
I don't know if home depot has them or not but they should.  by the way this is the same guy i just changed my tag line

-------------




Posted By: jseibold
Date Posted: December 16, 2008 at 10:09 PM

i guess i didnt change my signature.............nevermind



-------------




Posted By: ajan246
Date Posted: December 17, 2008 at 12:22 AM
hey man i went to HD and they had them in tons of different sizes! Thanks for the tip! I'm doing this install for my GF, you saved me some embarassement posted_image posted_image posted_image





Print Page | Close Window