Print Page | Close Window

remote start in 98 4runner

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=109896
Printed Date: July 18, 2025 at 5:28 AM


Topic: remote start in 98 4runner

Posted By: sheldeezy22
Subject: remote start in 98 4runner
Date Posted: December 20, 2008 at 6:21 AM

im tryin 2 hook up the HT-800d alarm in a 1998 toyota 4runner... and i dont know how 2 hook up the 2nd ignition wire but i kno i need 2 use a relay but dont kno how to run the wires for the relay and from the relay to the alarm



Replies:

Posted By: sinkhole
Date Posted: December 20, 2008 at 9:10 AM
It's fairly simple. What you are trying to do is feed power to the 2nd ignition line. Hook up the relay as follows.
30 - to 2nd ignition
85 - to ignition aux. output from remote start (-) or status (-)
86 - to 12 volt
87 - to 12 volt
Be sure to use heavier gauge wire for 30 & 87 as this will be a higher current circuit.



Posted By: sheldeezy22
Date Posted: December 20, 2008 at 4:44 PM

-sinkhole

thanks i appreicate at that...that really help...i haven't hooked it up yet...but do any of them have 2 b ground...i thought that number 86 was a ground




Posted By: sinkhole
Date Posted: December 20, 2008 at 9:36 PM
85 from the remote start sends the ground to the coil to trigger the relay.



Posted By: sheldeezy22
Date Posted: December 21, 2008 at 3:39 AM
ok so the wire from the remote start is serving as a ground...



Posted By: sheldeezy22
Date Posted: December 22, 2008 at 12:46 PM
the door locks but  i cant get the remote start to work....


Print Page | Close Window