01 pathfinder remote start problem

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=109898
Printed Date: May 28, 2024 at 3:01 AM

Topic: 01 pathfinder remote start problem

Posted By: richid
Subject: 01 pathfinder remote start problem
Date Posted: December 20, 2008 at 8:14 AM

Hi,

2001 Nissan Pathfinder LE - all stock - new remote start.

After reading through all of the great info here I was able to install a new remote starter, bypass, relays, diodes, etc. and it works great. The only problem is that the new fob unlock sets off the factory alarm. If I start it first, it works fine - just unlocking sets it off. So it seems that the car is not seeing the 'disarm' as part of the unlock.

I did have trouble locating the wires for the lock/unlock on the 'smart' module as the factory manual nor the aftermarket ones list the pin locations. Did I pick the wrong unlock wire ?

Thanks,

-Rich

Replies:

Posted By: sinkhole
Date Posted: December 20, 2008 at 8:21 AM

What remote start are you using and what by-pass module?

Posted By: richid
Date Posted: December 21, 2008 at 8:20 AM

Here they are :

Commando EZ-2500 with BYPASS TBKIII

Thanks,

-Rich

Posted By: prdjr165
Date Posted: December 21, 2008 at 8:27 AM

did you set it for double pulse on unlock?

Posted By: jinstall
Date Posted: December 21, 2008 at 10:48 AM

hey man check for a brown wire at the security module. staub includes that as a note on disarm. doesn't say where the security module is but those one's are usually pretty easy to find.

Posted By: jinstall
Date Posted: December 21, 2008 at 10:49 AM

if you get that all done and your arm doesn't work staub also has a note that rearm is a ltGREEN/ red at the same module. hope this works!

Posted By: richid
Date Posted: December 23, 2008 at 11:18 AM

Thanks - I found the security module to tap the wires, there are two GREEN/ red - I'll check for the brown wire.

It is set for double pulse - it unlocks fine, just sets off the alarm.