compustar priority driver’s unlock?

Installing a Compustar 2W900FM in a 93 Acura Integra. The unit has a driver's priority unlock feature that I'd like to hook up. Compustar won't give me info because I'm not a dealer (just DYI in my own car).

Can anyone tell me how this get's wired up?

-------------
Anthony

what type of locking system do you have, i'm not familiar with that vehicle.

-------------
COMMIT YOUR WAY TO JEHOVAH AND HE WILL ACT IN YOUR BEHALF. PSALMS 37:5

it must be actuator 5W. i had a 93 integra as well and it had no power locks. i knew some others that had that car as well and they didnt have power locks.

It's does have factory power door locks. It's negative switched.

what else do you need to know?

-------------
Anthony

ok, so you take the alarm negative lock trigger an the second unlock negative trigger to the lock an unlock wires respectively, then your primary unlock wire goes through a relay to the driver side acftuator unlock, of course assuming if u have central unlocking u eliminated it. merry christmas

-------------
COMMIT YOUR WAY TO JEHOVAH AND HE WILL ACT IN YOUR BEHALF. PSALMS 37:5

Can you expand on that a bit, I'm still a bit confused.

-------------
Anthony

ok, the two trigger wires in ur car from the factory locking module, one pulses ground to lock and the other ground to unlock, they will have constant voltage on them at rest, (the voltage varies so i won't say what they read at rest), but both wires will have around the same readin at rest, the one that goes to zero when you lock, you connect your lock wire to that, the one that goes to ground when you unlock connect your second unlock to, then locate ur actuator wires,  (easily accesible behind driver door panel), one pules 12volts when you lock and the other 12 when u unlock, (they read ground at rest), the one that pulses 12 when u unlock is the one you need, cut the wire an install a relay, using the primary unlock wire. not sure if i helped, probably there's someone who can make it simpler.

-------------
COMMIT YOUR WAY TO JEHOVAH AND HE WILL ACT IN YOUR BEHALF. PSALMS 37:5

Here's the diagram for 5W rest at ground, which is how your driver's door unlock will get connected. (More details past the image.)



For your primary unlock you'll use the left half of that diagram. The main unlock wire from the Compustar goes to pin 86 or 85(it doesn't matter which terminal unless there's a diode across the terminals).

The "unlock" wire on the car(shown as pink in the picture) will be your driver's door unlock motor lead, which would probably be yellow with a stripe on a Honda product. This wire will show 12 volts when the unlock switch is pressed, and 0V otherwise. Also when it is cut the driver's door power lock will stop working but other doors will still work.



-------------
C Renner's Auto Electronix
My service is cheap, quick, and good - pick any two