auto timer, tach, 08 fit
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=110108
Printed Date: July 12, 2025 at 7:59 PM
Topic: auto timer, tach, 08 fit
Posted By: hulk88
Subject: auto timer, tach, 08 fit
Date Posted: December 28, 2008 at 6:09 AM
hi, may i know how to install a d1 spec 5 in 1 auto timer to a 2008 fit? after i install and activate the timer, my door can only be lock after engine stalls... and where is the tach wire located at???
Replies:
Posted By: hulk88
Date Posted: December 28, 2008 at 4:08 PM
still waiting for the answer...
Posted By: hulk88
Date Posted: December 28, 2008 at 4:19 PM
hi all, need to find the tach wire for my 2008 honda fit i-vtec engine, and also anyone can guide me how to install a turbo timer. cos after i install, i cant lock the door until engine stalls...
Posted By: tedmond
Date Posted: December 28, 2008 at 10:50 PM
tach - GREEN/ ORANGE @ fuse box. set DMM to ac and test. OR set to frequency hz and test for fluctuating numbers. what turbo timer? you will need to tap into ignition and tach.
Posted By: tedmond
Date Posted: December 28, 2008 at 10:54 PM
i just read the first post. the reason you canr lock the doors is because the car sees that the ignition is still powered, therfore the must be a key inside the ignition cylinder. only after ignition is cut will doors lock. theres no real way around this but to get a keyless entry unit
Posted By: hulk88
Date Posted: December 29, 2008 at 4:07 AM
there is no GREEN/ orange... mine is a 08 fit... not the old model ...
Posted By: tedmond
Date Posted: December 29, 2008 at 8:16 AM
its there... look around. its in a 6pin connector in the fusebox
Posted By: hulk88
Date Posted: December 29, 2008 at 4:22 PM
tedmond wrote:
its there... look around. its in a 6pin connector in the fusebox
ok thanks i will try to find... and can you guide me on the steering column wiring colour. as i might have connect the wrong ones. there is white,red,orange,pink,yellow.
Posted By: tedmond
Date Posted: December 29, 2008 at 8:52 PM
Battery (+) - WHITE
Ignition (+) - BLACK / YELLOW
Accessory 1 (+) - YELLOW/BLACK
Accessory 2 (+) - WHITE/ RED
Starter (+) - BLACK/ WHITE
did you even test the wires? or did you just splice into the wires?
Posted By: KarTuneMan
Date Posted: December 30, 2008 at 8:03 AM
Tach is white on one of the coils on top on da engine. more than likely also found INSIDE the car as Teddy stated! -------------
Posted By: tedmond
Date Posted: December 30, 2008 at 8:55 AM
haha, i was just going to mention if he couldnt find it, run it out to the engine bay and look for the odd colour at the injectors and splice into it.
Posted By: hulk88
Date Posted: December 30, 2008 at 4:33 PM
tedmond wrote:
Battery (+) - WHITE
Ignition (+) - BLACK / YELLOW
Accessory 1 (+) - YELLOW/BLACK
Accessory 2 (+) - WHITE/ RED
Starter (+) - BLACK/ WHITE
did you even test the wires? or did you just splice into the wires?
Sir, i think you dun get what i mean... the colour stated at my steering column does not have the colour code you state. i have state the colour that was there in my post eariler... my wire are all in single colour...
Posted By: tedmond
Date Posted: December 30, 2008 at 11:12 PM
i crossed referanced my wiring charts and those wires are the ones that should be at the steering column. pop the shroud off and unplug the harness comming from the ignition switch. I know on some hondas, from the ignition switch down to mid knee kick panel, the harness is plugged into another harness and changes colour. Make sure you got the right wires. dont want to burn ou ta turbo timer.
|